Difficulty

Easy

Steps

8

Time Required

                          5 minutes

Sections

1

  • Keyboard
  • 8 steps

Flags

0

  • BackHP Pavilion x360 11m-ad013dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Keyboard
  • Lay the HP Pavilion top-down with the front edge facing towards you.

Lay the HP Pavilion top-down with the front edge facing towards you.

1024

Step 2

  • Remove the three 4.8mm Phillips #0 screws from the front side.

Remove the three 4.8mm Phillips #0 screws from the front side.

Step 3

  • Using a plastic spudger, remove the grey silicon strip closest to the back-side.

Using a plastic spudger, remove the grey silicon strip closest to the back-side.

Step 4

  • Remove the three 5.7mm Phillips #1 screws.

Remove the three 5.7mm Phillips #1 screws.

Step 5

  • Open the HP Pavilion so that the screen is showing. Then tilt it down so that the screen is on its back, facing up.
  • Using a spudger, pry off the black keyboard panel.
  • This step requires force to unclasp the latches keeping the keyboard in place.

Open the HP Pavilion so that the screen is showing. Then tilt it down so that the screen is on its back, facing up.

Using a spudger, pry off the black keyboard panel.

This step requires force to unclasp the latches keeping the keyboard in place.

Step 6

  • Using your fingernail, disconnect the zero insertion force (ZIF) keyboard connector cable by flipping up the small locking flap.
  • You may disconnect the other end of the cable, for ease of access to other parts. Keep in mind that the end labeled MB connects to the motherboard.

Using your fingernail, disconnect the zero insertion force (ZIF) keyboard connector cable by flipping up the small locking flap.

You may disconnect the other end of the cable, for ease of access to other parts. Keep in mind that the end labeled MB connects to the motherboard.

Step 7

  • Using your fingernail, disconnect the zero insertion force (ZIF) connector for the touch pad cable by flipping up the small locking flap.

Using your fingernail, disconnect the zero insertion force (ZIF) connector for the touch pad cable by flipping up the small locking flap.

Step 8

  • Remove the keyboard.

Remove the keyboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Hank Ferguson

Member since: 01/13/2020

590 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Eastern Washington University, Team S1-G1, Carnegie Winter 2020                        

                                                  Member of Eastern Washington University, Team S1-G1, Carnegie Winter 2020 



                    EWU-CARNEGIE-W20S1G1                     


                                            3 Members                     


                                            5 Guides authored