Hp Pavilion Zd8000 Switch Cover Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          7 minutes            

Sections

3

• Battery
• 2 steps
• WiFi Card Cables
• 2 steps
• Switch Cover
• 3 steps

Flags

0

• BackHP Pavilion zd8000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Slide the battery release latch towards you.

Slide the battery release latch towards you.

1024

Step 2

• Pull up on the battery to remove it.

Pull up on the battery to remove it.

Step 3

              WiFi Card Cables               

• Unscrew the four 8mm Philips screws marked with an icon resembling a stacks of discs.
• Lift the cover from the right to remove it.

Unscrew the four 8mm Philips screws marked with an icon resembling a stacks of discs.

Lift the cover from the right to remove it.

Step 4

• Use tweezers to detach the grey and black cables connected to the green WiFi card.

Use tweezers to detach the grey and black cables connected to the green WiFi card.

Step 5

              Switch Cover               

• Place the laptop face-down and rotate it 180 degrees so the vents are facing you.
• Remove the five 8mm Philips screws. Three are on the black base and two are near the hinges.

Place the laptop face-down and rotate it 180 degrees so the vents are facing you.

Remove the five 8mm Philips screws. Three are on the black base and two are near the hinges.

Step 6

• Flip the laptop over.
• Fully open the laptop.

Flip the laptop over.

Fully open the laptop.

Step 7

• Rotate it so the display is on your right and the keyboard is on your left.
• Lift the switch cover firmly but slowly so you do not snap it.
• Lift the switch cover carefully from one end while sliding the spudger between the switch cover and the laptop to separate them.
• The switch cover should easily separate from the laptop as you run the spudger through.

Rotate it so the display is on your right and the keyboard is on your left.

Lift the switch cover firmly but slowly so you do not snap it.

Lift the switch cover carefully from one end while sliding the spudger between the switch cover and the laptop to separate them.

The switch cover should easily separate from the laptop as you run the spudger through.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    Allie Menard                     

Member since: 04/12/2011

820 Reputation

                                      13 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Cal Poly, Team 24-56, Amido Spring 2011                        

                                                  Member of Cal Poly, Team 24-56, Amido Spring 2011 



                    CPSU-AMIDO-S11S24G56                     


                                            4 Members                     


                                            13 Guides authored