Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
2
- Outer Casing
- 7 steps
- Camera Lens Assembly
- 2 steps
Flags
0
BackHP Sprocket 2-in-1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Casing
- Remove the back cover and any printer paper inside the device.
Remove the back cover and any printer paper inside the device.
1024
Step 2
- Using the Jimmy, slowly pry open the outer edge of the remaining white plastic on the back.
- Remove the plastic from the device once it lifts out freely.
Using the Jimmy, slowly pry open the outer edge of the remaining white plastic on the back.
Remove the plastic from the device once it lifts out freely.
Step 3
- Remove two 2.5mm JIS #00 located on the small circuit board in view.
- Use the Jimmy to remove the board after the screws have been removed.
- Be careful not to crease or damage the ribbon cable.
Remove two 2.5mm JIS #00 located on the small circuit board in view.
Use the Jimmy to remove the board after the screws have been removed.
Be careful not to crease or damage the ribbon cable.
Step 4
- Remove two 2.5mm JIS #00 screws from the translucent plastic bracket.
- One will be located beneath the ribbon cable.
- Remove the translucent plastic bracket by hand.
Remove two 2.5mm JIS #00 screws from the translucent plastic bracket.
One will be located beneath the ribbon cable.
Remove the translucent plastic bracket by hand.
Step 5
- Remove four 2.5mm JIS #00 screws from the beige casing.
Remove four 2.5mm JIS #00 screws from the beige casing.
Step 6
- Use the iFixit opening tool to slowly work between the white and beige casing around the device.
- Flip the device over and seperate the white casing from the rest of the device.
- Be careful not to break the plastic while removing the case.
- Gently remove the white casing as there is a ribbon cable connecting the two pieces.
Use the iFixit opening tool to slowly work between the white and beige casing around the device.
Flip the device over and seperate the white casing from the rest of the device.
Be careful not to break the plastic while removing the case.
Gently remove the white casing as there is a ribbon cable connecting the two pieces.
Step 7
- Carefully remove the ribbon cable that connects the flash to the outer casing.
Carefully remove the ribbon cable that connects the flash to the outer casing.
Step 8
Camera Lens Assembly
- Use the Japanese Industrial Standard J00 screwdriver to remove five 2.5mm screws.
- One of the screws is below bronze tape. Move the tape slightly to get to the screw.
- Remove the metal plate from the casing.
Use the Japanese Industrial Standard J00 screwdriver to remove five 2.5mm screws.
One of the screws is below bronze tape. Move the tape slightly to get to the screw.
Remove the metal plate from the casing.
Step 9
- Use an iFixit opening tool to pry the camera free from the device.
Use an iFixit opening tool to pry the camera free from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Paulo Warren
Member since: 02/05/2019
437 Reputation
4 Guides authored
Badges:
6
+3 more badges
Team
University of Michigan, Team S1-G4, Li Winter 2019
Member of University of Michigan, Team S1-G4, Li Winter 2019
UMIC-LI-W19S1G4
4 Members
5 Guides authored
