Difficulty
Moderate
Steps
10
Time Required
Suggest a time??
Sections
3
- Battery
- 2 steps
- Screen
- 5 steps
- Front Camera
- 3 steps
Flags
0
BackHTC Rezound
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Use a plastic opening tool or your fingers to get into the groove between the cover and case. Remove the back covering so that the red battery is visible.
Use a plastic opening tool or your fingers to get into the groove between the cover and case. Remove the back covering so that the red battery is visible.
1024
Step 2
- Remove the red battery to replace.
Remove the red battery to replace.
Step 3
Screen
- Unscrew the six screws (Torx T4 size) shown in the photo.
- Use the spudger to pry the casing off of the phone.
Unscrew the six screws (Torx T4 size) shown in the photo.
Use the spudger to pry the casing off of the phone.
Step 4
- Gently remove the casing from the phone.
Gently remove the casing from the phone.
Step 5
- After the red casing is removed, the following components should be visible:
- Main Camera
- Headphone Jack
- Vibration moter
After the red casing is removed, the following components should be visible:
Main Camera
Headphone Jack
Vibration moter
Step 6
- Remove the 2 screws (Torx T7 size), which are located on the upper left and lower right sides of the device.
Remove the 2 screws (Torx T7 size), which are located on the upper left and lower right sides of the device.
Step 7
- Using tweezers, flip the latch on the ribbon cables connecting the logic board to the screen and display. The screen and display for the HTC Rezound are likely fused to one another, so if you are replacing one you will likely need to replace both of them.
- At this point all that’s left is to insert the ribbon cables of your replacement into the same slot on the motherboard!
Using tweezers, flip the latch on the ribbon cables connecting the logic board to the screen and display. The screen and display for the HTC Rezound are likely fused to one another, so if you are replacing one you will likely need to replace both of them.
At this point all that’s left is to insert the ribbon cables of your replacement into the same slot on the motherboard!
Step 8
Front Camera
- Shown here is the camera that you will be replacing today!
Shown here is the camera that you will be replacing today!
Step 9
- Carefully flip the latch for the ribbon cable that connects the camera to the logic board.
- Firmly grasp the cable, without crimping it, and slid it out of the slot.
Carefully flip the latch for the ribbon cable that connects the camera to the logic board.
Firmly grasp the cable, without crimping it, and slid it out of the slot.
Step 10
- Take the replacement camera and start to line it up with the slot in the logic board.
- Fix ribbon cable to the slot and turn the latch back down to lock in place.
Take the replacement camera and start to line it up with the slot in the logic board.
Fix ribbon cable to the slot and turn the latch back down to lock in place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Evan Swartz
Member since: 01/29/2018
181 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
University of Alabama, Team S3-G12, Bedsole Spring 2018
Member of University of Alabama, Team S3-G12, Bedsole Spring 2018
UA-BEDSOLE-S18S3G12
4 Members
7 Guides authored
