Huawei Mate 10 Pro Back Cover Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 - 40 minutes

Sections

SIM Card Tray
1 step
Back Cover
4 steps

Flags

BackHuawei Mate 10 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

If your battery is swollen, do not heat your phone. Swollen batteries can be very dangerous, so wear eye protection and exercise due caution, or take it to a professional if you’re not sure how to proceed.

What you need

Step 1

              SIM Card Tray

Insert a SIM opening tool in the hole on the left side and push it in.
Remove the SIM card tray.

Insert a SIM opening tool in the hole on the left side and push it in.

Remove the SIM card tray.

1024

Step 2

              Back Cover

Switch off your phone.
Prepare an iOpener and apply it to the back of the phone for about two minutes to loosen the adhesive beneath the back cover.

Switch off your phone.

Prepare an iOpener and apply it to the back of the phone for about two minutes to loosen the adhesive beneath the back cover.

Step 3

Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.
Use the halberd spudger to cut the adhesive beneath the back cover on all sides of the phone.
Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.

Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.

Use the halberd spudger to cut the adhesive beneath the back cover on all sides of the phone.

Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.

Step 4

Don’t remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard.
Flip the back cover over to the side.
Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.

Don’t remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard.

Flip the back cover over to the side.

Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.

Step 5

Use a pair tweezers to remove the metal shield covering the connector of the fingerprint sensor.
Disconnect the fingerprint sensor cable with a spudger.
When reassembling your phone apply new adhesive where it is necessary.

Use a pair tweezers to remove the metal shield covering the connector of the fingerprint sensor.

Disconnect the fingerprint sensor cable with a spudger.

When reassembling your phone apply new adhesive where it is necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      11 other people completed this guide.

Author

                                      with 1 other contributor

                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored

Luis Liberato - Aug 31, 2018

Where can I buy the back part of the phone. Email me at brownpridebandit@gmail.com

amoudi Guide - Dec 1, 2018

Thanks for good work you do

Introduction#

What you need#

Team#

Introduction

What you need

Team