Huawei P10 Lite Rear Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 - 45 minutes

Sections

Back cover
4 steps
Battery Disconnection
1 step
Rear Camera
1 step

Flags

BackHuawei P10 Lite
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back cover

Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.
Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.
If the adhesive is hard to cut, use an iOpener to loosen it.

Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.

If the adhesive is hard to cut, use an iOpener to loosen it.

1024

Step 2

After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.
Flip the rear cover over to the right side of the phone.

After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

Flip the rear cover over to the right side of the phone.

Step 3

Use a pair of tweezers to remove the sticker.
Remove the two Phillips #00 screws.
Remove the four 2.5 mm Phillips #00 screws.

Use a pair of tweezers to remove the sticker.

Remove the two Phillips #00 screws.

Remove the four 2.5 mm Phillips #00 screws.

Step 4

Use tweezers to remove the mainboard shield.
Use the flat end of a spudger to disconnect the finger print sensor flex cable.
When reassembling apply new adhesive where it is necessary.

Use tweezers to remove the mainboard shield.

Use the flat end of a spudger to disconnect the finger print sensor flex cable.

When reassembling apply new adhesive where it is necessary.

Step 5

              Battery Disconnection

Remove the Phillips screw holding the battery connector plate in place.
Remove the battery connector plate.
Use the flat end of a spudger to disconnect the battery flex cable.

Remove the Phillips screw holding the battery connector plate in place.

Remove the battery connector plate.

Use the flat end of a spudger to disconnect the battery flex cable.

Step 6

              Rear Camera

Use the flat end of a spudger to disconnect the rear camera flex cable.
Remove the rear camera.

Use the flat end of a spudger to disconnect the rear camera flex cable.

Remove the rear camera.

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team