Difficulty
Moderate
Steps
5
Time Required
25 minutes
Sections
2
- Back Cover
- 3 steps
- Headphone Jack
- 2 steps
Flags
0
BackHuawei P9
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- First switch off your phone and remove the SIM card tray.
- Unscrew the two Pentalobe P2 screws located at the bottom next to the device’s USB C port.
- If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
First switch off your phone and remove the SIM card tray.
Unscrew the two Pentalobe P2 screws located at the bottom next to the device’s USB C port.
If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
1024
Step 2
- Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
- Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
- In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
- Don’t remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.
Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
Don’t remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.
Step 3
Fingerprint sensor
- Disconnect the fingerprint sensor using a spudger.
Disconnect the fingerprint sensor using a spudger.
Step 4
Headphone Jack
- Remove the water indicator on top of the screw.
- Undo the two Phillips #00 screws.
- Remove metal bracket (mind the adhesive underneath).
Remove the water indicator on top of the screw.
Undo the two Phillips #00 screws.
Remove metal bracket (mind the adhesive underneath).
Step 5
- Disconnect the flex cable and remove the headphone jack.
- The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.
Disconnect the flex cable and remove the headphone jack.
The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 2 other contributors
Tobias Isakeit
Member since: 03/31/2014
105,397 Reputation
184 Guides authored
Badges:
46
+43 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,769 Guides authored
abcde181 - Mar 23, 2019
Reply
questo procedimento funziona anche con il modello p9 plus? grazie per l’attenzione
