Huawei P9 Rear Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 minutes

Sections

Back Cover
3 steps
Rear Camera
2 steps

Flags

BackHuawei P9
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

First switch off your phone and remove the SIM card tray.
Unscrew the two Pentalobe P2 screws located at the bottom next to the device’s USB C port.
If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

First switch off your phone and remove the SIM card tray.

Unscrew the two Pentalobe P2 screws located at the bottom next to the device’s USB C port.

If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

1024

Step 2

Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
Don’t remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

Don’t remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

Step 3

              Fingerprint sensor

Disconnect the fingerprint sensor using a spudger.

Disconnect the fingerprint sensor using a spudger.

Step 4

              Rear Camera

Undo the two Phillips #00 screws.
Remove the bracket.
Mind the connector underneath.

Undo the two Phillips #00 screws.

Remove the bracket.

Mind the connector underneath.

Step 5

Release the connector.
Loosen the camera from the motherboard and take it away.

Release the connector.

Loosen the camera from the motherboard and take it away.

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 2 other contributors

                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team