Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
2
- Back Cover
- 2 steps
- USB Port
- 3 steps
Flags
0
BackiNet M1001
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the two 4.1 mm PH1 screws with a Philips screwdriver.
Remove the two 4.1 mm PH1 screws with a Philips screwdriver.
1024
Step 2
- Press the small suction cup on the back cover, and then pull the small suction cup to remove the back cover.
Press the small suction cup on the back cover, and then pull the small suction cup to remove the back cover.
Step 3
USB Port
- Remove the two 3.8 mm PH1 screw with a Philips screwdriver.
Remove the two 3.8 mm PH1 screw with a Philips screwdriver.
Step 4
- Remove the USB port from it’s plastic housing.
Remove the USB port from it’s plastic housing.
Step 5
- Desolder the white wire, and pull it off of the motherboard.
- Check out this awesome guide for tips on soldering and desoldering.
Desolder the white wire, and pull it off of the motherboard.
Check out this awesome guide for tips on soldering and desoldering.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Abdulateef Abola
Member since: 03/08/2017
401 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
IUPUI, Team 4-1, Baechle Spring 2017
Member of IUPUI, Team 4-1, Baechle Spring 2017
IUPUI-BAECHLE-S17S4G1
2 Members
8 Guides authored
