Difficulty

Difficult

Steps

9

Time Required

                          40 minutes

Sections

2

  • Battery
  • 4 steps
  • USB Port
  • 5 steps

Flags

1

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

  • BackInsignia NS-SPBTBRICK

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the rubber sleeve.

Remove the rubber sleeve.

1024

Step 2

  • Use the specified screwdriver to unscrew the ten screws on the back cover.

Use the specified screwdriver to unscrew the ten screws on the back cover.

Step 3

  • Remove the back cover. Be careful to not lose any of the screws because they are extremely small and can be easily lost.

Remove the back cover. Be careful to not lose any of the screws because they are extremely small and can be easily lost.

Step 4

  • The battery will be attached to the back cover with sticky tape. Unplug the wires connecting the battery to the speaker.

The battery will be attached to the back cover with sticky tape. Unplug the wires connecting the battery to the speaker.

Step 5

              USB Port
  • Once the battery and back cover have been successfully removed, use the soldering iron. Place the soldering iron on the solders until properly heated.

Once the battery and back cover have been successfully removed, use the soldering iron. Place the soldering iron on the solders until properly heated.

Step 6

  • Once the metal is heated, it will be easy to remove the piece. Be careful not to alter the circuit board in any way with the heat. Use tweezers to remove the old part. Be careful not to touch the piece with your hands because the piece will be very hot.

Once the metal is heated, it will be easy to remove the piece. Be careful not to alter the circuit board in any way with the heat. Use tweezers to remove the old part. Be careful not to touch the piece with your hands because the piece will be very hot.

Step 7

  • Once the switch has been removed properly, place the new switch in the same spot as the old one.

Once the switch has been removed properly, place the new switch in the same spot as the old one.

Step 8

  • Use the soldering iron to melt the existing solders and attach the new switch onto where the old switch was located.

Use the soldering iron to melt the existing solders and attach the new switch onto where the old switch was located.

Step 9

  • After the new piece is properly melted into place, put the battery and back cover onto the device and screw the cover back on using the specified screwdriver and the ten screws.

After the new piece is properly melted into place, put the battery and back cover onto the device and screw the cover back on using the specified screwdriver and the ten screws.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Erin Steele

Member since: 03/08/2017

649 Reputation

                                      5 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       UMass Dartmouth, Team S5-G2, Botvin Spring 2017                        

                                                  Member of UMass Dartmouth, Team S5-G2, Botvin Spring 2017 



                    UMASSD-BOTVIN-S17S5G2                     


                                            2 Members                     


                                            6 Guides authored