Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

3

  • Spinning Brush
  • 2 steps
  • Battery
  • 3 steps
  • Drive Wheels
  • 1 step

Flags

0

  • BackiRobot Roomba 690

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Spinning Brush
  • Place the Roomba upside down so that the wheels and brushes are facing upward.

Place the Roomba upside down so that the wheels and brushes are facing upward.

1024

Step 2

  • Loosen the captive screw in the spinning brush using a Phillips #0 screwdriver.
  • Remove the spinning brush from the vacuum.

Loosen the captive screw in the spinning brush using a Phillips #0 screwdriver.

Remove the spinning brush from the vacuum.

Step 3

              Battery
  • Remove the four 6.4 mm screws from the bottom of the Roomba using a Phillips #0 screwdriver.
  • They are labeled with triangular arrows next to them on the cover.

Remove the four 6.4 mm screws from the bottom of the Roomba using a Phillips #0 screwdriver.

They are labeled with triangular arrows next to them on the cover.

Step 4

  • Lift the bottom cover up from the rest of the Roomba.

Lift the bottom cover up from the rest of the Roomba.

Step 5

  • Lift out the battery by pulling up on the two flexible tabs that are attached to the left and right sides.

Lift out the battery by pulling up on the two flexible tabs that are attached to the left and right sides.

Step 6

              Drive Wheels
  • Each drive wheel is labeled left and right.
  • Remove three 12 mm screws from each drive wheel using a Phillips #0 screwdriver.
  • Remove the drive wheels from the vacuum.

Each drive wheel is labeled left and right.

Remove three 12 mm screws from each drive wheel using a Phillips #0 screwdriver.

Remove the drive wheels from the vacuum.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    John Galvin

Member since: 03/23/2022

557 Reputation

                                      5 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team 1-1, Botvin Spring 2022                        

                                                  Member of UMass Dartmouth, Team 1-1, Botvin Spring 2022 



                    UMASSD-BOTVIN-S22S1G1                     


                                            3 Members                     


                                            5 Guides authored