Difficulty

Very difficult

Steps

5

Time Required

                          15 - 45 minutes

Sections

2

  • Front Panel
  • 3 steps
  • Microphone
  • 2 steps

Flags

0

  • BackJabra Freeway

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Panel
  • Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.
  • Remove the rubber pads from the bottom of the device using the spudger.

Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.

Remove the rubber pads from the bottom of the device using the spudger.

1024

Step 2

  • Remove the eight 6mm T9 screws.
  • Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.

Remove the eight 6mm T9 screws.

Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.

Step 3

  • Gently lift the front panel off of the device and carefully rest it to the side.

Gently lift the front panel off of the device and carefully rest it to the side.

Step 4

              Microphone
  • Remove the microphone from the microphone holding slot.

Remove the microphone from the microphone holding slot.

Step 5

  • Desolder the two wires connecting to the microphone.
  • Please refer to the soldering technique guide for instructions on desoldering and soldering.

Desolder the two wires connecting to the microphone.

Please refer to the soldering technique guide for instructions on desoldering and soldering.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Alec Wilson

Member since: 10/19/2016

714 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 4-8, Catania Fall 2016                        

                                                  Member of UMass Dartmouth, Team 4-8, Catania Fall 2016 



                    UMASSD-CATANIA-F16S4G8                     


                                            2 Members                     


                                            6 Guides authored

Edmond Lleshi - Dec 25, 2019

Reply

Perfect, thank you.

Steve MacLeod - Aug 31, 2020

Reply

Based on my limited experience with this device, the component being replaced here is the secondary, or noise-cancelling microphone - not to be confused with the primary microphone. The other video showing replacement of the motion detector seems to be actually replacing the primary microphone.