Jabra Freeway Motion Detector Replacement Repair Guide

Difficulty

Very difficult

Steps

Time Required

                          10 - 50 minutes

Sections

Front Panel
3 steps
Motion Detector
2 steps

Flags

BackJabra Freeway
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Panel

Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.
Remove the rubber pads from the bottom of the device using the spudger.

Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.

Remove the rubber pads from the bottom of the device using the spudger.

1024

Step 2

Remove the eight 6mm T9 screws.
Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.

Remove the eight 6mm T9 screws.

Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.

Step 3

Gently lift the front panel off of the device and carefully rest it to the side.

Gently lift the front panel off of the device and carefully rest it to the side.

Step 4

              Motion Detector

Use the plastic opening tool to lift the motion detector off the circuit board.
The motion detector is glued in place, so a moderate amount of force is required.

Use the plastic opening tool to lift the motion detector off the circuit board.

The motion detector is glued in place, so a moderate amount of force is required.

Step 5

Desolder the two wires connecting the motion detector to the circuit board.
Please refer to the soldering technique guide for instructions on desoldering and soldering.

Desolder the two wires connecting the motion detector to the circuit board.

Please refer to the soldering technique guide for instructions on desoldering and soldering.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Alec Wilson

Member since: 10/19/2016

714 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 4-8, Catania Fall 2016                        

                                                  Member of UMass Dartmouth, Team 4-8, Catania Fall 2016 



                    UMASSD-CATANIA-F16S4G8                     


                                            2 Members                     


                                            6 Guides authored

Steve MacLeod - Aug 31, 2020

Based on my limited experience with this device, the component being replaced here is the primary microphone - not the motion detector as claimed. The other video showing replacement of the microphone is actually the secondary, or noise-cancelling microphone. I don’t know the exact components for the motion detector, but I’m quite sure that this is not that component.

Introduction#

What you need#

Team#

Introduction

What you need

Team