Difficulty

Moderate

Steps

6

Time Required

                          30 minutes - 1 hour

Sections

2

  • Speaker Bezel
  • 2 steps
  • Rear Panel
  • 4 steps

Flags

0

  • BackKindle Fire HDX 7"

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Follow this guide to replace it, or remove it to get to the interior components.

What you need

Step 1

              Speaker Bezel
  • Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.
  • The adhesive is strong and may require an iOpener, or heat gun, to soften.

Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.

The adhesive is strong and may require an iOpener, or heat gun, to soften.

1024

Step 2

  • Remove the speaker bezel.

Remove the speaker bezel.

Step 3

              Rear Panel
  • Remove the six pink 3mm T3 Torx screws from the back case.

Remove the six pink 3mm T3 Torx screws from the back case.

Step 4

  • Wedge opening picks around the perimeter between the display and back case.
  • Work the opening picks around the perimeter until the two halves disengage from each other.
  • Don’t completely separate as the display ribbon cable still connects the two.

Wedge opening picks around the perimeter between the display and back case.

Work the opening picks around the perimeter until the two halves disengage from each other.

Don’t completely separate as the display ribbon cable still connects the two.

Step 5

  • Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.

Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.

Step 6

  • There may be a glue strip between the battery and the outside case. Gently pry the case open and use the flat end of a spudger to separate the glue strip.

There may be a glue strip between the battery and the outside case. Gently pry the case open and use the flat end of a spudger to separate the glue strip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Blake Klein

Member since: 01/29/2017

66,666 Reputation

                                      54 Guides authored                  



                       Badges:
                       43







                                                        +40 more badges