Difficulty

Easy

Steps

6

Time Required

Suggest a time??

Sections

3

  • Top Cover
  • 3 steps
  • Gear Housing Cover
  • 2 steps
  • Worm Gear
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackKitchenAid Professional 600

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Top Cover
  • Take out the screw which holds on the silver band using a Phillips #2 screwdriver.
  • Remove the silver band.

Take out the screw which holds on the silver band using a Phillips #2 screwdriver.

Remove the silver band.

1024

Step 2

  • Remove the four Phillips #2 screws located around the mixer where the band was removed.
  • This picture only shows two of the screw that you need to remove. The other two are on the exact opposite side of the mixer.

Remove the four Phillips #2 screws located around the mixer where the band was removed.

This picture only shows two of the screw that you need to remove. The other two are on the exact opposite side of the mixer.

Step 3

  • Remove the top of the mixer to reveal the inner parts.
  • The top should lift off, but may not if it is stuck. A sharp strike from the back with the hand may unstick it. It will slide forward about a 3/8 of an inch. Push it back again from the front and it should be free enough to lift.

Remove the top of the mixer to reveal the inner parts.

The top should lift off, but may not if it is stuck. A sharp strike from the back with the hand may unstick it. It will slide forward about a 3/8 of an inch. Push it back again from the front and it should be free enough to lift.

Step 4

              Gear Housing Cover
  • Remove the 4 Phillips #2 screws connecting the black housing cover to the device.
  • Only one of the screws is seen in the picture. The other three are also located around the black housing cover.

Remove the 4 Phillips #2 screws connecting the black housing cover to the device.

Only one of the screws is seen in the picture. The other three are also located around the black housing cover.

Step 5

  • Take off the black housing cover.

Take off the black housing cover.

Step 6

              Worm Gear
  • Remove the Worm Gear.
  • The Worm Gear is the part that is lying horizontal.
  • Remember to apply food safe grease onto your new replacement part before assembling the device back together.

Remove the Worm Gear.

The Worm Gear is the part that is lying horizontal.

Remember to apply food safe grease onto your new replacement part before assembling the device back together.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.

Author

                                      with 1 other contributor 


                    Luke

Member since: 04/11/2016

1,225 Reputation

                                      5 Guides authored                  



                       Badges:
                       19







                                                        +16 more badges

Team

                       Cal Poly, Team 25-4, Maness Spring 2016                        

                                                  Member of Cal Poly, Team 25-4, Maness Spring 2016 



                    CPSU-MANESS-S16S25G4                     


                                            4 Members                     


                                            14 Guides authored